Longshine LCS-IR2114-D - Manual (Page 45)

IP Sharing Router
- 45 -
Static Routes Configuration
It is the address of the network or host that you want to assign to a static route Destination Network
IP
It determines which portion of an IP address is the network portion, and which
portion is the host portion
Subnet Mask
This is the IP address of the gateway device that allows for contact between
the router and the network of host.
Gateway IP
To add / Modify a static routing entry:
Step 1: Click Add / Modify button, you will see a new screen as the below.
Step 2: Enter the appropriate Destination IP Address, Subnet Mask and Default Gateway, and then select
the status
Step 3: Click OK to make the entry take effect.
3.6.3 Dynamic Routing
Dynamic Routing can be used to cache routes learned by routing protocols, thus allowing the automation
of static routing maintenance. The router, using the RIP (Routing Information Protocol) protocol,
determines the network packet's route based on the fewest number of hops between the source and the
destination. In the working mode, router stands for normal rip router. Default gateway stand for router
announces default route on both sides. The rip function is workable only when WAN mode was set to
Static IP or DHCP.