Longshine LCS-KL-2716M - Manual (Page 31)

30
7.4 Auto-Scan in OSD: <F2>
7.4.1 Start to auto-scan in OSD
Press <F2> in OSD main menu. The auto-scan banner will be shown to
indicate the scanning channel.
─┬── ┬ ──┬──────
│
│ └─
Channel Name
│ └──────────
Channel Number
└───────────────
Indicate now is Scan Mode
Auto-Scan Banner
Note: You can also start auto-scan function via hot key by using
<Scroll Lock> →
→ → → <Scroll Lock> → → → → <S> → → → → <Enter> outside the
OSD mode. Please refer section 6.6.1 Start Auto-Scan Function.
7.4.2 Stop auto-scan
Press any key on keyboard to STOP the auto-scan function. The
auto-scan banner will disappear when the scan stops.
7.4.3 Auto-scan mode
There are two auto-scan modes, please refer section 7.3.1 Setup in
OSD – Scan Mode to set up the auto-scan mode.
Scan all computers which are power on.
Scan all computers which are marked for auto-scan.
7.4.4 Auto-scan time interval
The auto-scan time interval of each port displayed can be adjustable by
pressing <F1> in OSD main menu. Please refer section 7.3.2 Setup in
OSD – Scan Time.