Malone MPG460G 2010 - Manual (Page 16)

MPG460G 01-2010
800-295-0042 ext 206 [email protected] 16
9. Press the brown wire into the quick connec-
tor as shown. Then insert the wire from the side
marker light fully into the 2nd opening. Use
pliers to squeeze the conductor blade down
and thru the insulation. The blade cuts thru the
insulation and connects the wires inside. Flip
the cover to lock the connector. Repeat on the
other side again using the brown wire.
12. There are holes in the back side of
each lamp marked by wire color. Identify
which hole is for which color
wire. Then carefully push
the twisted wire straight into
the corresponding hole.
You will feel the wire slide
under the wire gripper inside
the lamp as you push the
wire into it. Once the wire
is pushed in it will not come
back out. Tug gently to
check for a good connection.
Repeat on the other side.
11. Strip 1/2” of insulation off the ends of
all 4 tail light wires. Twist the exposed
copper strands to stiffen them.
10. Route the wires out to the tail
lights via the slotted hole under
the lamp brackets. Determine how
much excess wire to cut off. Be
sure and leave yourself a few inch-
es of extra wire. You can always
cut away more later if need be.