Malone MPG460G 2010 - Manual (Page 22)

MPG460G 01-2010
800-295-0042 ext 206 [email protected] 22
3. Use your hammer and carefully pound the end plugs into
the ends of the support
tubes. Install the caps onto
the ends of the U-bolts.
5. Slip 2 carriage bolts into
the end of each load bar.
4. Install the load bar brackets onto the ends of each
tube and turn the bracket so the 2 hole flange is level.
Snug the mounting bolt.
6. Flip the load bar over and insert the
carriage bolts into the load bar brackets. Add
nuts, center the bar and tighten.
7. Install the end caps on the load bars
8. Go back now and re-check that all nuts and bolts
on the entire trailer are securely tightened.