Malone MPG460G 2010 - Manual (Page 20)

MPG460G 01-2010
800-295-0042 ext 206 [email protected] 20
3. Place the skid and chain
assembly under the tongue
and insert the bolt up through
the skid bolt hole on the bot-
tom of the tongue as shown.
4. Slip the ring terminal over
the bolt and install the nylon
lock nut hand tight.
5. Check that the rear end
of the skid is still in its hole
in the bottom of the tongue.
Tighten the bolt while holding
the nut stationary. This way the ring terminal remains straight.
6. Install the coupler on
the tongue and fully tighten
as shown. Tighten until
the coupler is tight onto
the tongue. Don’t crush
the coupler and tongue by
tightening excessively.