Cisco WIP310 - Manual (Page 12)

Chapter 2
Installing the WIP310
8 Wireless-G IP Phone
Chapter 2:
Installing the WIP310
Installing the Battery
Open the phone’s back battery cover Place the battery
so that the metal contacts on the battery touch the metal
contacts in the battery compartment The battery fits only
one way Do not force Replace the cover after the battery
is installed
Battery Installed
Charging the Battery
Inserting the Power Adapter
Insert the power adapter into the charger and then insert
the adapter into a wall outlet Charge the phone by placing
the phone into the charger
NOTE: You can also charge the phone using the
USB cable Connect one end to your phone and
the other end to a USB port on your personal
computer
The phone briefly displays a charging icon and the LED is
solid red When the LED is solid green, the phone is fully
charged
NOTE: The battery needs to charge for
at least 8 hours prior to the phone’s initial
use Do not power on the phone until it has
charged for at least 8 hours
Powering On the Phone
Power on the phone by pressing and holding the Power/
End Call button for approximately five seconds until the
screen is lit The phone is ready to use when the Home
screen appears (in approximately 30 seconds)
Home Screen
Powering Off the Phone
Power off the phone by pressing and holding the Power/
End Call button until the screen becomes dark
Installing the Phone
To use your Wireless-G IP Phone, you need the following:
Access to a Wireless-B or Wireless-G network with •
Internet access
An account with an Internet Telephony Service
•
Provider (ITSP)
To use your phone, you need to complete the following
tasks:
Connect to a wireless network 1
Register your phone with your ITSP If you received 2
your phone directly from your ITSP, it should be pre-
configured and should perform this step automatically
after you power on the phone