Moog Crossbow GNAV540 - Manual (Page 43)

GNAV540 User Manual
7430‐0808‐01 Rev. B Page 43
Chapter 5. Installation Guidelines
This ch boratory test. apter provides information to set up the GNAV540 unit and NAV‐VIEW 2.2 software for la
NOTE: D a unit in a vehicle for field use is outside the scope of this document. irections to install
• Overview, page 43
• Installation Requirements, page 43
• 1. Install Software—NAV‐VIEW 2.2, page 44
•
age 2. Prepare the Communication Port, p
•
44
3. Connect the GPS Antenna, page 44
• 4. Turn on the GNAV540 , page 45
Overview
The following instructions are for connecting the GNAV540 unit to a computer and using NAV‐VIEW 2.2 to verify
basic functions of the unit in a laboratory setting.
Installation Requirements
Computer
• CPU: ≥ 1GHz
• RAM Memory: ≥ 3GB
• Hard Drive Free Memory: ≥ 60MB
•
XP, 32 bit or 64 bit; Windows 7, 32 bit or 64 bit Operating System: Windows
• Microsoft .NET 4.0 or higher
Communication Port
• For a serial connection, which COM port to use.
• Fo
VA540 unit and the IP port number r an Ethernet connection, the IP address of the GN
NOTE: The default IP address of the unit is 192.168.1.2.
Power and Hardware
Power:
• to +32 VDC Voltage: +9 VDC
• Power: > 5 W
Hardware:
• Ensure all necessary hardware has been determined and provided.
• Optional: For laboratory test, a cable is provided with the Crossbow evaluation kit. Refer to Figure 31 on
page 126.
NOTE: The kit cable is only suitable for laboratory test; it is not designed for field use. Refer to Figure 31 on
page 126.