Motion Pro 01-0057 - Manual

Turbo™ THROTTLE P/N 01-0057
1. Remove the cover screw and lift housing cover (F) and guide wheel (G) off. Remove two socket head screws and
separate housing halves (A & B) and throttle sleeve (H).
2. Insert cable through hole in housing top half (A). Wrap around guide wheel (G) and push guide wheel back in place.
3. Insert cable ball end into slot in throttle sleeve drum and place throttle sleeve (H) into housing top half (Note proper
position of throttle sleeve in images below). Set housing bottom half (B) on and check that the sleeve rotates freely
with definite stop at throttle off position.
4. Insert two socket head screws loosely and slide assembly over end of lightly greased handlebar. The end of the
sleeve should be even with the end of the handlebar. Set housing cover in place and tighten the cover screw. Turn
assembly to desired position and tighten socket head screws evenly while retaining equal spacing (gap) between the
housing halves at both sides of the handlebar. Do not exceed 26 inch pounds (3 Nm). Normally the correct position
is with the cable running across the top and forward of the handlebar.
CORRECT
THROTTLE
TUBE POSITION
Throttle tube cable tangs
are rotated back into
housing and not visible.
When cap is in position,
throttle tube is able to
rotate back into housing
normally.
INCORRECT
THROTTLE TUBE
POSITION
Cable mount tangs on
throttle tube are visible.
When the cap is installed,
the tube tangs are trapped
and will break off against
the cable guide portion of
the cap.
Parts Available Individually:
(C) P/N 00-0869 Rubber Boot
(D) P/N 00-0956 Cable Adjuster
(E) P/N 00-0877 Cable Adjuster Nut
(H) P/N 01-0089 Throttle Sleeve
Optional
P/N 01-0072 Throttle Sleeve
(to open Mikuni VM40mm and larger)
(A) Housing Top Half (B) Housing Bottom Half (D) Cable Adjuster (G) Guide Wheel (H) Throttle Sleeve
(E) Cable Adjuster Nut
(C) Rubber Boot (F) Housing Cover & Screw
I01-0057 11/2012