Muse Research Receptor manual v1.2 - Manual (Page 19)

1: Quick Start 19 Receptor Manual
Connecting: Is my computer’s Ethernet port already in use?
You computer’s Ethernet port may already be in use if you’re connected to a cable/DSL modem or to an
existing network. Check to see whether or not you’re already using your computer’s Ethernet port, and proceed
as follows:
•
If your computer’s Ethernet port is not in use, you can connect Receptor directly to your computer using a
“special” Ethernet cable known as a ‘crossover Ethernet cable.’ This cable is available from most computer
supply stores and differs from a standard Ethernet cable. Always make sure, when connecting Receptor
directly to a computer (without going through a router/switcher) that you use a crossover Ethernet cable.
• If your computer’s Ethernet port is in use, that means you’ll have to use an Ethernet router/switcher to
connect Receptor and your other Ethernet devices to your computer. Ethernet routers/switchers are widely
available from most computer supply stores. Follow the instructions that come with your router/switcher
and be sure to use standard Ethernet cables (not crossover cables) when connecting all your devices.