Muse Research Receptor manual v1.2 - Manual (Page 81)

6: Editing, Saving, and Metering 81 Receptor Manual
SAVE/FILE: Rename Patch
To rename a patch:
1 Rotate the top display knob to select the Rename Patch option.
2 Rotate the bottom display knob to select the bank that contains the patch you wish to rename.
The bank name is flashing, indicating you must press the bottom display knob to apply your selection.
0 1 R e n a m e P a t c h <
III III B a n k : M e l l o w S o u n d s
3 Press the bottom display knob to apply.
The bottom line of the display is now used for selecting which of that bank’s 128 patches you wish to rename.
4 Rotate the bottom display knob to select the patch you wish to rename.
The patch number is underlined and flashing, indicating you must press the bottom display knob to apply your
selection.
0 1 R e n a m e P a t c h <
III III 0 2 6 : f u n K E Y
5 Press the bottom display knob to apply your selection.
The display will now allow you to rename the patch.
0 1 R e n a m e ( C u r s o r < > ) <
III III 0 2 6 : f u n K E Y
Rotate the top display knob to move the cursor. Rotate the bottom display knob to change the character over which the
cursor appears. The entire patch name flashes, indicating you must press the bottom display knob to apply the name
change.
NOTE: You can delete the underlined character by pressing the top display knob.
6 Rotate the top and bottom display knobs to rename your bank, then press the bottom display knob to
apply the name change.
The display will ask if you’re sure.
0 1 A r e y o u s u r e ? <
III III N o
7 Rotate the bottom display knob counter-clockwise to select No, or clockwise to select Yes. Make sure Yes
is shown and press the bottom display knob to apply.