Casio XJ-460 - Manual (Page 5)

Projection Operations
5
Auto Input Source Selection
When you turn on the projector, it checks the status of each input source (whether or not
the input source is sending a signal) in the sequence shown below. It automatically selects
the first input source it finds that is sending an input signal, and projects the applicable
image.
If the RGB input terminal is connected to a computer and the S-VIDEO input terminal is
connected to a video deck and signals are being supplied by both, for example, the projector
automatically selects RGB input when it is turned on. The currently selected input source
name is shown in the upper right corner of the projection screen.
z If the projector does not find any input signal, the message “No signal input” appears in
place of the input source name.
z Whether the displayed input source name shows [RGB] or [Component] depends on the
current “Input Settings
J RGB Input” (page 42) setting that is configured on the
projector’s setup menu.
z Note that the projector does not select the input source automatically when “Off” is
selected for the “Option Settings1
J Auto Input Detect” (page 45) setting on the setup
menu.
RGB terminal input VIDEO terminal input S-VIDEO terminal input
(RGB/Component) (VIDEO) (S-VIDEO)