NORAC UC4+BC+GM1 - Manual (Page 28)

26
10. The connectors on the valve cable
(C03) are marked RIGHT UP, LEFT
UP, RIGHT DOWN and LEFT
DOWN. Cables labeled with UP go
on the same side as the hydraulic hoses.
Figure 32: Valve Cable Connections
11. Connect the CAN Node cable (C02B)
to the 4-pin AMP plug on C11.
12. Route the CAN Node cable (C02B) to
the roll sensors which are installed in
Section 1.1. Follow existing cables
and/or hydraulic lines.
13. Connect 4-pin AMP connectors on
C02B to the sensors. Connect the
sensor branch cable (C02) to the 4-pin
AMP plug on C02B (Figure 33).
Figure 33: Cable Configurations: C01,
C02, C02B, C03 and C04
14. Route the sensor branch cable (C02) to
the wing and main sensors and connect
to the sensors. Follow existing cables
and/or hydraulic lines along the boom.
15. Cable-tie the installed cables every 12
inches.
IMPORTANT:
Provide enough slack in all cables to
account for the movement of the
main section, parallel lift, and
FOLDING boom movement.