Canon RE-350 - Manual (Page 17)

AUDIO
OUT
VIDEO S VIDEO RGB
R G
OUT EXIT
AC INLET
AC OUTLET
75 OFF ON
24/96
100/60
ID 0
ID 1
RS-232C
SYNC OFF ON IN B
R L SYNC
1 0
E
To output to a RGB monitor,
connect the RE-350 to a
monitor with RGB input terminal
using a commercially available
RGB cable. If using a RGB
monitor without a SYNC
terminal, set the SYNC
selection switch to ON. The
RGB monitor projects pictures
via the camera head,
regardless of the selection of
input equipment.
SYSTEM CONSTRUCTION 4
16
The RE-350 has abundant video input and output terminals.The equipment shown below can be connected
to these terminals. Use the specified power cord. For other cords, use commercially available cables. For
details of operation, refer to the instruction manual of the equipment to be used.
Computer Video monitor
VCR
RGB monitor
Computer
S-video cable
RCA pin
cable
RGB cable
RCA pin
cable
Rear panel
RS-232C cable
Power cord
Outputting to a RGB
monitor
To AUDIO IN To VIDEO IN To S-VIDEO IN
To AUDIO OUT To VIDEO OUT To S-VIDEO OUT
For connecting power cords
to Video camera, VC-C1, VCR,
VIZCAM1000,etc.(up to 5A in total)
Output Equipment
Video camera, VC-C1,
VCR, VIZCAM1000, etc.
To control by a computer
To control certain functions of the RE-350 by a computer, complete
the following steps:
ቢ Connect the RE-350 to the computer using a RS-232C cable.
ባ Set the electronic shutter, communication speed and ID number.
ቤ Turn ON the power to the equipment.
ብ Operate the computer.
For details, please consult Canon U.S.A.
VC-C1
Video camera
VCR
Input Equipment
BNC video cable
To 120VAC
power outlet
S-video
cable
BNC
video
cable
VIZCAM 1000
RGB projector
BNC video cable
Video camera,
speakers with an
amplifier, etc.