O.S. Engines FS-40S-CX - Manual (Page 9)

AIR CLEANER TYPE 102S
INSTALLATION OF AIR CLEANER
Carefully clean the
carburettor, removing any
old adhesive or sealant
that may have been
previously used on the
outside of the air intake. •
Press the air cleaner body firmly over the
carburettor air intake. Make sure that the outer
rim of the air intake engages the internal
annular groove in the air cleaner: failure to do
so may result in the air cleaner falling off. •
It has a single filter element and is intended
primarily for circuit racing, where conditions are
less damaging than the very dusty, loose surfaces
of off-road operation for which the double-element
Type 101 and 102 Air Cleaners are recommended.
The lower height of the Super Air-Cleaner 102S
also facilitates easier installation in cars where
available space may be restricted.
NOTE:
Where spacers are supplied joined in pairs
(see sketch), separate them as shown.
Either face may be placed downwards.
Secure with locknuts. If the bottom of the recoil
starter housing would otherwise touch the car
chassis, install the engine mount spacers
(supplied) between the engine's mounting lugs and
the engine mount. Use the M3.5x15 screws
provided. With some vehicles, it may be necessary
to make minor trimming modifications to chassis or
body when fitting the engine.
Mount Spacer
Separate
Engine Mount Engine Mount Spacer
8