Oakworks CFLU401 - Manual (Page 21)

18
DIReCTIons FoR Use
CaUTIon
ReMoVe / RePLaCe THe TaBLe ToP PaD
Make sure the top is not in motion when removing / replacing the table top pad.
Underside of Tabletop
Remove Table Pad by pulling flaps at the ends & sides
of the table until the hook and loop fastener becomes
unanchored.
Replace pad by first centering on the table and then
pressing flaps in place, anchoring with the hook and
loop fasteners.
aDjUsTInG THe CRanIaL PosITIonInG PaDs
(InTeGRaTeD HeaDResT ToPs onLy)
Prone Positioning:
The Crescent Face Pad is held in place by hook &
loop fasteners.
Place close in to the edge of the table with sides
together for smaller patients or further away from
the edge with sides apart for larger patients.
supine Positioning: (accessory)
Pads attach to the integrated face rest extension with hook & loop fasteners that hold the pad securely in place.
Pads are provided that give two levels of elevation: 2” or 4” (5 or 10cm)
2” or 4”
(5 or 10cm)