Caution, Directions for use, Carbon fiber arm board (accessory) – Oakworks CFLU401 User Manual
Page 26: Adjustable t-rail clamp use (accessory)
23
DIReCTIons FoR Use
CaRBon FIBeR aRM BoaRD (aCCessoRy)
CaUTIon
Do not place undue weight or downward pressure on the Carbon Fiber Arm Board. It is a posi-
tioning device for the arms and should not be used as leverage to get on or off the table. Injury
can occur. DO NOT exceed 30 lbs. (14 kg.) of load on the
Support Section. Injury can occur.
Use
This radiolucent device can be used with any flat support surface where ionizing radiation (x-ray) is utilized for imag-
ing. It can be used to support arms and feet.
Directions
Unfold the Arm Board and slide the Base Section under the patient and the table pad. Position the patient and the
Support Section
to suit the needs of the procedure. The weight of the patient will hold the Arm Board in place.
Rotate the Support Section to the desired position. This section rotates up to 180º.
To remove the Arm Board, ask the patient to move their limb off the Support Section and lift their body slightly. This
will allow you to pull out the base section of the Arm Board.
Fold the Base and Support sections for storage.
Prone Position at 135º
Supine Position at 180º
Support Section
Base Section
aDjUsTaBLe T-RaIL CLaMP Use (aCCessoRy)*
1. Open T-rail clamp.
2. Slide T-rail to desired location.
3. Tighten T-rail clamp.
Note: The Integrated T-Rails are US standard
size of .38” (1cm) thick by 1.13” (3cm) wide.
*Not for use on CFPMB301 - Bariatric table