Canon H12157 - Manual (Page 56)

2-22 Setting Up Your LASER CLASS 2060P Chapter 2
Connecting the Power Cord
Follow these guidelines when connecting your LASER CLASS 2060P to a
power source:
❏ The LASER CLASS 2060P is intended for use in the U.S. and Canada
only and requires 120 V AC. Do not use it outside the U.S. or Canada.
❏ Plug the LASER CLASS 2060P only into a 120-volt AC, 60 Hz,
three-prong grounded outlet.
❏ Use only the power cord that came with the unit. Using a longer cord
or extension cord can cause the LASER CLASS 2060P to malfunction.
❏ Unplug the unit only by pulling on the plug itself. Never pull on the
cord.
❏ The LASER CLASS 2060P is equipped with a 3-prong, grounding-
type plug (the third pin is a grounding pin). This plug will only fit
into a grounding-type outlet. This is a safety feature. If you are unable
to insert the plug into your outlet, contact an electrician to replace
your outlet (do not use a 3-to-2 adapter). Do not defeat the safety
purpose of the grounding-type plug.
❏ Do not plug the LASER CLASS 2060P into an outlet shared with an
appliance such as an air conditioner, computer, electric typewriter, or
copier. These devices generate electrical noise, which can interfere
with the operation of the LASER CLASS 2060P.
❏ Make sure nothing is laying on the power cord, and that the cord
cannot be walked on or tripped over.
❏ Do not overload the electrical outlet. Make sure the total amperage
used by all the machines plugged into the outlet does not exceed the
ampere rating of the outlet’s circuit breaker.
❏ Do not plug the unit into an uninterruptible power supply (UPS).
C