Cary Audio Design HD Surround Sound Processor Cinema 11a - Manual (Page 49)

SETUP MENU
48
2. Use the  and  button to select the NORMAL mode or INVERT.
When you select NORMAL mode, the Zone 1 Rear IR optional remote control sensor
output Polarity is positive.
When you select INVERT mode, the Zone 1 Rear IR optional remote control sensor output
Polarity is negative. This setting selects the polarity of the Zone 2 rear IR sensor.
To set Zone 2 Rear IR Mode:
When you select NORMAL, the Polarity is positive. When you select INVERT, the Polarity is
negative.
1. Press the  button until REAR IR Mode is selected.
The ADVANCED SETTING / REAR IR Mode menu appears.
2. Use the
 and  button to select the NORMAL mode or INVERT.
When you select NORMAL mode, the Zone 2 Rear IR optional remote control sensor
output Polarity is positive. When you select INVERT mode, the Zone 2 Rear IR optional
remote control sensor output Polarity is negative.
TO SET TRIGGERS
1. Press the  button until TRIGGERS is selected.
The OTHER/ TRIGGERS menu appears.
2. Use the  and  buttons to select the zone of triggers.
If select the ZONE 1, a 12-volt trigger signal is output when zone 1 is turned on the
Cinema 11a.
If select the ZONE 2, a 12-volt trigger signal is output when zone 2 is turned on the
Cinema 11a.
If select the ZONE 1 & 2, a 12-volt trigger signal is output when Cinema 11a is turned
on.
TO SET AUTO INPUT SEEK
1. Press the  button until AUTO INPUT SEEK is selected.
The OTHER/ AUTO INPUT SEEK menu appears.
2. Use the  and  buttons to select the auto input detect on or off.
When you select ON, the Cinema 11a can automatically detect input sources.
TO SET LATE MODE FOR DOLBY DIGITAL
1. Press the  button until LATE is selected.
2. Use the  and  buttons to select the LATE mode in Off, Half and Full.