Philips 19SV07B - Manual (Page 7)

M enu
C hannel A uto M emo
C hannel Auto Memo (or
First Time Setup) takes
care of some basic TV settings
for you. Follow the steps in this
section:
• to set the language of the
TV’s menu
® to add channels into the
TV’s memory
• to set the TV for Antenna or
Cable TV signal
connections.
These instructions apply only
when you turn on the TV the
first time. After the TV has been
turned on for the first time, or if
you want to set up the TV chan­
nels and language later, refer to
the information on page 5.
How
TO S et U p and U se your
KemlH)
■<3>
Be sure to connect the
TV power cord to a standard
AC outlet.
Press the POWER
button to turn the TV ON.
The language selection menu
appears on the TV screen.
SELECT LANGUAGE ^
> ENGLISH ON
ESPAÑOL
SELECT AT OR
PRESS MENU TO CONTINUE
<s>
Press the CH(annel) MW
buttons to select English or
Spanish. Then, press the
MENU button.
<S>
Press the VOL(ume) + but­
ton to begin automatic channel
setup.
When setup is complete,
CHANNELS ARE SET will
appear on screen.
<i>
Press the
STATUS/EXIT but­
ton to exit the
SETUP menu.
T elevision
—(BEGINÌ
<i>
Press the POWER
button to turn the TV ON.
<l>i Press the VOLUME
(+) or (-) button to adjust
the sound level.
<i> Press the CHANNEL
(A) or (▼) button to select
TV channels.
Press the MENU button to dis­
play the TV’s on screen menu.
Press the CHANNEL (A) or (▼)
button to select an item in the menu.
Press the VOLUME (+) or (-) but­
ton to adjust an item in the menu.
Note: Select EXIT in the on screen
menu, then press the VOLUME (+)
button to remove the menu.
The tuned ^
channel number
will appear when
you turn on the TV
and when you
change channels. To
display the channel
number at all times,
set REMINDER to
ON. See page 6 for
details.
R emote ■iBEGINL
T o load the batteries into
the remote:
1. Slide off the battery com­
partment lid on the
remote control.
2. Insert two AA batteries
(supplied) into the bat­
tery compartment as
indicated by the + / -
markings inside the bat­
tery compartment.
Batteries installed incor­
rectly may damage the
remote control.
3. Replace the lid.
Battery
Compartment
Lid
Battery
Compartment
r<i>
Point the remote con­
trol toward the remote sen­
sor on the TV when operat­
ing the TV with the remote.
Menu Buttons
Press to access the on screen menu. Press
the CH(annel) A/T buttons to select an
item in the menu. Press the VOL(ume)
+/- buttons to adjust an item in the menu.
Power Button
Press to turn the TV ON and OFR
Number Buttons
Press two number buttons to select a TV
channel. For example, to select channel
6, press 0,6.
When you select channels which are
equal or greater than the number 100,
press the +100 button, then press the last
two digits of the channel you want. For
example, to select channel 117, press the
+100 button, 1,7.
CH(annel) A/T Buttons
Press to scan through programmed chan­
nel numbers.
Press to select an item in the on screen
menu.
Status/Exit Button
Press to see the current channel number
on the TV screen. Press to exit the menu.
Sleep Button
Press to set the TV to turn itself OFF
automatically.
“Alt. Ch (Alternate Channel) Button
Press to return to the TV channel you
were viewing immediately before switch­
ing to your current channel.
"Mute Button
Press to eliminate the TV sound. Press
again to restore the sound.
VQL(ume) +/- Buttons
Press to adjust the TV sound level.
Press to adjust an item in the menu
(BRIGHTNESS, for example) or to
advance to the next menu.