Char-Broil 463247310 - Manual (Page 16)

5
6
16
Upper back panel
1/4-20x1½”
screw
7mm lock
washer
7mm flat
washer
On back of grill, place upper back panel between side panels and above lower back panel. Secure upper back panel, in
lower holes, using one 1/4-20x1½” screw, 7mm lock washer, and 7mm flat washer on each side.
Do not fully tighten screws until side shelf installation is complete in later steps.
Release the cap and nut from electronic ignition module. Attach electronic ignition module and heat shield to the cart right
side panel with the nut and cap.
Lower back panel
Heat Shield
Nut
Cap
Right side panel
Electronic ignition
module
NOTE: Parts and wires omitted for
clarity of illustration