Char-Broil 463247310 - Manual (Page 18)

8
18
Remove the four screws and washers factory attached to the Auto Clean valve bracket. Position Auto Clean valve bracket
beneath right side shelf fascia so that valve stem comes through larger center hole in fascia. Align the four holes on valve
bracket with the four holes on fascia. Secure using screws and washers that were removed from bracket, shown A.
Screws and Washers removed
from valve bracket
A
#8-32x1/4” screw
4mm lock washer
Bezel(blank)
knob
B
Auto Clean
valve bracket
valve stem
Place the blank bezel over valve stem on front side of the fascia. Align small holes on bezel with the holes on fascia.
Attach using two #8-32x1/4” screws and 4mm lock washers. Press control knob on to valve stem, shown B.