Philips VRB661AT - Manual (Page 9)

With this connection:
• You may watch one channel while recording another.
• You may not record scrambled channels.
Hookups with a Cable Box/Direct Broadcast System (confd) 9
1
-or
2
Connect a Cable signal to the VCR’s ANT(enna) IN Jack.
Use an RF coaxial cable (supplied) to connect the OUT Jack on the VCR
to the IN Jack on the Cable Box/DBS.
3
Use a second RF coaxial cable to connect the OUT Jack on the Cable
Box/DBS to the ANTENNA IN Jack on the TV.
Recording One ChannelA/Vatching Another
I
Put the Cable Box/DBS on the same channel as the VCR’s CH3/CH4
switch. Set the TV to the Cable Box/DBS output channel (03 or 04).
Then, with the VCR in VCR position (the VCR light will appear on the
display panel), use the CH(annel) button to select the chan­
nel you want to record at the VCR. Start the recording.
2
Press the VCR/TV button once to put the VCR in TV position.
(The VCR light will disappear.)
3
Sele
4
Select the channel you want to watch at the Cable Box/DBS.
To return to the channel you are recording, set the Cable Box/DBS to
the same channel as the VCR’s CH3/CH4 switch. Press the VCR/TV but­
ton so that the VCR is in VCR position again.The VCR light will appear
on the display panel.The channel you are recording will appear on the
screen. Press the STOP/^ button to stop recording.
Helpful Hint
When you play a tape, make sure
the Cable Box/DBS is set to the
same channel as the CH3/CH4
switch on the VCR. Set the TV to the
Cable Box/DBS output channel (03
or 04).