Philips QT4070-32 - Manual (Page 9)

Storage
I Be sure Trimmer is turned off and remove cord
from outlet and Trimmer before storing in a
safe, dry location where it will not be crushed,
banged, or subject to damage.
► Do not wrap cord around Trimmer when
storing.
K Store Cord in a safe location where it will not
be cut or damaged.
► Do not place or store Trimmer where it can
fall or be pulled into a tub or sink, water or
other liquid.
Battery Removal
► This Philips Norelco Trimmer contains a
rechargeable Lithium-Ion battery
which must be disposed of properly (fig. 18).
► Battery may only be removed when
Trimmer is to be discarded.
I For assistance, visit our website:
www.philips.com/noreico or call
toll free 1-800-243-3050.
I Unplug electrical cord from outlet and
Trimmer before dismantling Trimmer.
a
Allow the Trimmer to run until the battery is
empty/depleted.
D
Turn Trimmer OFF.
Q Open the lid of the hair collection
chamber (fig. 12).
B Remove the 4 screws inside the hair chamber
with a screwdriver (fig. 19).
□ Pull the hair-collection chamber out of the
appliance with some force (fig. 20).
I To remove the front panel, wedge a
screwdriver between the front panel and
the inside of the appliance (fig. 21).
B
Remove the 4 screws on the inside of the
appliance (fig. 22).
□ Remove the inner panel (fig. 23).
\E
Remove the printed circuit board with the
rechargeable battery connected to it (fig. 24).
m Cut the wires between the printed circuit
board and the rechargeable battery.
\E
Do not attempt to replace battery. Insulate
battery ends by covering with tape and/or
place battery in a small plastic bag.
\E
Discard your Trimmer. Do not attempt to
plug electrical cord into the outlet or
recharge the Trimmer after the battery has
been removed.
[E
Contact your local town or city officials for
battery disposal information or call
I -800-8-BATTERY or www.rbrc.com for
battery drop-off locations.