Philips 32PT6441-37 - Manual (Page 6)

C
able
B
ox
C
onnections
J
If your cable signal uses a cable
Xbox or decoder, follow the easy
steps below to complete the connec­
tion.
Cable Box (w/RF In/Outputs):
This connection will be mono.
1 Connect the Cable Company
supplied cable to the simal
IN(put) plug on the bacK of the
Cable Box.
2
Using a separate round coaxial
cable, connect one end to the
OUT(put) (TO TV) plug on the
back of the Cable Box.
3 Connect the other end of the
round coaxial cable to the 75Q
input on the back of the televi­
sion. Screw it down finger tight.
NOTE: If applicable, set the OUT­
PUT CHAMfeL SWITCH on the
back of the cable box to CH 3 or 4.
Tune the TV to the same channel and
change channels at the cable box. In
some cases, the cable box will auto­
matically tune to either channel 3 or 4,
change channels until the picture
appears.
Cable Box (w/AudioA^ideo
Outputs):
This connection will supply Stereo
sound.
4 Connect the Cable Company
pj^ed cable to the cable sig­
nal IN(put) plug on the back of
the Cable Box.
5 Using a RCA type Video Cable,
connect one end of the cable to
the Vdeo (or ANT, your cable
box may be labeled differently)
Out jack on the cable box and
the other end to the AVI Video
Input on the TV.
6
Connect one end of the Audio
Left and Right Cable to the left
and right Audio Out L & R
jacks on the cable box. Connect
the other end to the AVI Audio L
& R Input jacks on the TV.
NOTE: Use the CH-l- or CH- on the
TV remote control to tune to the AVI
channel for the cable box signal. Once
tuned, change channels at the cable
box, not the television.
SU]
Cable Box (w/RF In/Outputs):
Cable Signal IN from the
Cable Company
O 1^.^ oopepQiEi
i—^
Jack Panel Back of Cable Box
13
Round 75Q
Coaxial Cable
Jack Panel Back of TV
Cable Box (w/Audio/Video Outputs):
L H l D D D o a
Cable Signal IN
from the Cable .■ ■
Cotnpan^sliSn I Cable Box with A/V Outputs
o
' S
Audio Cables
L (White) & R (Red)
Jack Panel Back of TV