Perfect Aire PNC18000 - Manual (Page 9)

8
Required Tools/Hardware
• Pencil
• Level
• Tape measure
• Socket wrenches
• Phillips screwdriver
• Adjustable wrench or pliers
• Large flat blade screwdriver
Hardware
(Included - Packed with the unit)
Tools Required (Not Included)
7/16 inch Locking
screw and Flat
washer for window
panels
3/4 (or 1/2) inch
Long Hex-head
Screw
Safety Lock
1/2 inch Long
screw and Locknut
3/4 inch Long
Flat Head Bolt
and Locknut
Sill Angle
Bracket
Long hex-head
locking screw
for top angle,
side retainer
5 /16 inch Long
2 ea.
4
1
4 ea.
2 ea.
2
10
Foam insert 2
Window sash
seal foam
1
INSTALLATION INSTRUCTIONS
Read these instructions completely
and carefully.
IMPORTANT- Save these instructions.
IMPORTANT- Observe all
governing codes and ordinances.
Note to Consumer- Keep these
instructions for future reference.
Note to Installer- Be sure to leave these
instructions with the Consumer.
Completion time- Approximately 1 hour.
Skill level- Installation of this appliance
requires basic mechanical skills.
We recommend that two people install
this product.
Proper installation is the responsibility
of the installer.
Product failure due to improper installation
is not covered under the Warranty.
You MUST use all supplied parts and use
proper installation procedures as described
in these instructions when installing this air
conditioner.
BEFORE YOU BEGIN
Do not, under any circumstances, cut or
remove the third (ground) prong from the
power cord.
CAUTION
Do not change the plug on the power cord
of the air conditioner.
Aluminum house wiring may present special
problems- consult a qualified electrician.
When handling unit, be careful to avoid cuts from
sharp metal edges and aluminum fins on front and
rear coils.