phil&teds T2 travel cot - Manual (Page 5)

a
7.
Attach the straps on the side of the
T 2 to the corresponding snap half
way up the leg pole.
8.
Inflate the mattress by opening the
self inflating valve. Manually inflate
as desired. Close the valve securely
when finished.
9. Unzip the top mesh and place
the mattress inside, pressing it
into the fabric corners.
Important: When outdoors anchor the cot
to the ground by placing the supplied pegs
through the eyelets in the corner webbing.
down she goes
When dismantling, the cot goes in the bag first,
then the mattress. It does sound tricky, but once
you've done it it will seem very easy...trust us!
1.
Remove the mattress from the cot, undo the
valve and zip up the mesh top.
2.
Undo all the clips (if you wish) and the 'snaps'
on the leg poles.
3. Undo all poles from corner fittings one corner
at a time, and then pull apart the long side
poles and leg poles.
4. Each pole will now be approximately the
same length and the cot will essentially be flat
on the floor, in a rectanglular shape.
5. Fold the bottom left corner up to the middle
then fold the top right corner down to the middle.
&