PRG Bad Boy User Manual 1.6 - Manual (Page 39)

BAD BOY ® SPOT LUMINAIRE USER MANUAL 31
ACCESSORY OPTIONS
Follow Spot Operation
The Bad Boy Spot Luminaire may also be used as a follow spot fixture. A Follow Spot Handles Kit (28.9812.0688) is
available for this purpose. The kit includes three handles so that follow spot operation may be accomplished from the
side of the fixture (using the two side handles) or from the rear of the fixture (using the two rear handles). When
operating as a follow spot, the pan/tilt should be configured for "free" movement (refer to
"Enabling Pan/Tilt Free
Mode" on page 32).
To install follow spot handles:
Step 1. At Head Cover, remove two 8-32 x 3/8" PPB screws as shown in Figure 2-18.
Step 2. Install one Front Mount and two Rear Mounts using supplied hardware.
Figure 2-18: Installing Follow Spot Handles - Step 1
8-32 x 3/8" PPB Screw (2)
Front Handle Mount
(10.9812.0688)
Rear Handle Mount
(10.9812.0689)
8-32 x 5/8" SHCS Screw (2)
(53.6696.0625.0)
10-32 x 5/8" SCB Screw
(53.6515.0625.0)