PRG Mbox Studio Manual v3.6.1 - Manual (Page 23)

MBOX ® STUDIO USER MANUAL 17
Playing Back Video - Quick Start
Once a console has been connected, the MBOX fixtures patched, and the display device turned on, video can be
played back.
IMPORTANT! The following procedure assumes that some content has been placed at Folder 001 / File 001.
To immediately play back video:
Step 1. At console, select Master fixture and set its intensity to full.
Step 2. Select Layer 1 fixture and set its opacity to full. (Note that when viewing in the HUD, opacity will be shown
as "opac.") A white square should appear in the center of the display:
Step 3. With Layer 1 still selected, set Texture Folder to a value of 1. Then set Texture File to a value of 1. An image
should appear on the display.