Pro Boat PRB08000 - Manual (Page 5)

Impulse 9 • Blackjack 9
Battery Charger
Battery charging requires approximately 2 hours.
Instructions
1. Connect the Ni-MH peak charger to an AC power
source.
2. The Power LED and Charging LED will turn
GREEN when the charger is connected to the AC
power source.
3. Connect the EC2™ battery pack connector to the
charge connector.
4. The Charging LED will turn RED.
5. When the battery pack is fully charged, the Charging
LED will turn GREEN.
6. Disconnect the battery pack connector from the
charge connector.
7. Disconnect the charger from the AC power source.
CAuTION: If at any time during the charge
process the battery pack becomes hot to
the touch, unplug the battery immediately
and discontinue the charge process.
5
EN
Transmitter Battery Installation
This transmitter requires 4 AA batteries.
1. Remove the battery cover from
the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.