Pro Boat PRB2400 - Manual (Page 6)

❍ 7. Locate the end of the main sail marked "J".
Pass the line tied to the main sail through the
hole in the main sail boom (marked J). Pull the
line until the main sail is taut, and the distance
between the boom and sail is between 3/4"and
1
1 / 4
". Secure the excess line by wrapping it
around the cleat and placing the end of the
line in the notches of the cleat.
❍ 8. Locate the end of the main sail marked "I."
Pass the line tied to the main sail through the
hole in the boom mount (marked I). Position the
line so the distance between the boom and sail
is between 3/4" and 1
1 / 4
". Secure the excess line
by wrapping it around the cleat and placing the
end of the line in the notches of the cleat.
Note: Do not adjust the tension
of any of the lines at this time.
This will be done in Section 4,
“Adjusting the Rigging Cables.”
❍ 9. Carefully unwrap the top rigging line
marked "C."
❍ 10. Insert the line into the outer hole in the
spreader as shown.
Note:The spreader has a small
notch in the outer hole.The
inner hole will not be used,
making it easier to insert the line.
Simply push the rigging line
through the slot.
Section 2 – Rigging Installation
6