Section 10: troubleshooting guide – Pro Boat PRB2800 User Manual
Page 14
1
Problem
Solution
Engine will not start
Engine is not primed: Put a few drops of fuel into
the carburetor venturi and restart
Out of fuel: fill fuel tank
Improper fuel: use 20% Blue Thunder™
Improper glow plug: install proper glow plug
Glow igniter not charged: charge igniter
Dead glow plug: replace
Flooded engine: remove glow plug, invert boat and
engage the Tiger Drive to remove raw fuel from the
engine
Engine starts, then dies
Pressure line blocked or unhooked: connect or
replace fuel line
Reset needles to baseline setting: see Section 9
Engine starts and runs for several minutes, then dies
Bad glow plug: replace
Idle speed set too low: see Section 9
Improper needle settings: see Section 9
Glow plug failed due to lean engine setting: richen
carburetor settings and replace glow plug
Section 10: Troubleshooting Guide