Pro Boat PRB2800 - Manual (Page 8)


 2. Remove the hex screws that secure the clear
lid on the radio box.
 3. Remove the dry cell battery holder from the
radio box and unwrap the foam from around the
dry cell battery holder. Install 4 “AA” alkaline
batteries as shown. Note the proper polarity.
Wrap the battery box in foam.
 4. Re-install the battery holder into the radio
box and and secure the radio box lid with
the hex screws. Be sure that the gasket is
not pinched. Failure to properly seal the radio
box could result in damage to your radio
equipment. Insert the receiver antenna tube
into the clear lid.
Transmitter Batteries
 1. Remove the transmitter from the box.
 2. Remove the battery cover on the bottom
of the transmitter.
 3. Note the proper polarity and insert 8 “AA”
batteries into the transmitter.
 3. Secure the batteries using the battery cover.
 4. Turn on the radio and confirm that all LEDs
illuminate, indicating proper installation of fully
charged batteries.
 5. Turn the radio off.
Section 2: Receiver and Transmitter Batteries (continued)