Pro Boat PRB3050 - Manual (Page 8)

8
If you have any questions concerning the setup or running of your Volere 22 Brushless EP boat,
please call the Horizon Service Center toll-free at (877) 504-0233.
PRB3051 8.4V 2/3A 1600mAh Ni-MH Battery
PRB3052 Front Seat
PRB3053 Windshield
PRB3054 Steering Wheel
PRB3055 30 amp ESC with Reverse
PRB3056 550-size Motor
PRB3057 Motor Mount
PRB3058 Propeller with Drive Dog
PRB3059 Cooling System
PRB3060 Rear Hatch Cover
PRB3061 Rudder with Linkage
PRB3062 Hull Only
PRB3063 Boat Stand
PRB3064 Decal Sheet
PRB3065 Motor Coupler
PRB3066 Driveshaft with Stuffing Box
PRB3067 Hull Accessories
PRB8021 Transmitter
PRB8023 Receiver
PRB8024 Servo
 3. Remove any debris, burned oil or rust from
the driveshaft with fine emory cloth or
sandpaper. Thoroughly oil the driveshaft.
 4. Install the driveshaft back in the stuffing
box. Remember to install the white nylon washer,
drive dog, propeller and propeller nut back on the
driveshaft. Tighten the setscrew to secure the
driveshaft to the motor adapter.
Note : Running the Volere 22 EP RTR in salt
water could cause some parts to corrode. If you
run the boat in salt water, rinse it thoroughly
in fresh water after each use and lubricate the
drive system.
Because of its corrosive effects, running RC boats
in saltwater is at the discretion of the modeler.
Replacement Parts