Pro Boat PRB3250 - Manual (Page 5)

 
Unscrew the 2 knurled hatch-mounting screws from
the rear of the hatch. Lift the hatch from the boat.
Tools and Accessories Required
12 AA batteries
2.5mm hex wrench
Receiver Batteries
q 1. Remove the 2.5mm hex head screws that
secure the clear Lexan radio box cover.
q 2. Remove the receiver battery holder and install
4 “AA” alkaline batteries in the battery holder.
Note proper polarity.
q 3. Plug the switch harness into both the receiver
and the battery box following the instructions
provided with the radio. Secure the radio box
cover with the hex head screws.
Section 3: Removing the Canopy
Section 4: Installing the Radio System Batteries
Transmitter Batteries
q 1. Remove the transmitter from the box.
q 2. Remove the battery cover on the bottom
of the transmitter.
q 3. Insert 8 AA alkaline batteries into the battery
holder. Note proper polarity.
q 4. Insert the battery holder in the transmitter
following the directions provided with the
radio system.
q 5. Install the battery cover back into position on
the bottom of the transmitter.
q 6. Turn on the transmitter and confirm that the
LCD illuminates, indicating proper installation of
fully charged batteries.
q 7. Turn on the receiver switch and move the
controls. Confirm that all controls operate in
the proper direction and are controlled by the
proper transmitter input.
q 8. Turn the transmitter and the receiver switch
off. To keep the boat from receiving stray
signals, the transmitter should be turned on first,
followed by the receiver. Likewise, the receiver
should be turned off first, then the transmitter.
Note: Remember the transmitter
must be sending a signal the entire
time the receiver is on.
Section 4: Installing the Radio System Batteries (cont)