Pro Boat PRB3300 - Manual (Page 6)

6
Note: Refer to the radio
instructions for specific information
on transmitter setup.
It may be necessary to adjust the throttle
trim knob to stop the propeller from
turning while the throttle trigger is in the
neutral position.
Adjust the rudder trim knob so that the
rudder is centered prior to operation. You
may adjust this control to make the boat
run straight during operation.
Operate your Blackjack 26 Brushless
EP in low to medium wake conditions
to avoid having problems with the
boat overturning. If the conditions are
questionable, adjust the prop strut down
a bit to reduce the likelihood of having
the boat overturn. The motor mount is
slotted to allow you to move the motor
slightly when adjusting the outdrive.
Loosen the motor mounting screws when
adjusting the outdrive trim and retighten
after adjustment is complete.
You may also turn the dual rate dial down
to reduce rudder travel in rough water
conditions.
Throttle
Trim
Steering
Trim
Section 4: Adjusting the Transmitter
Section 5: Handling Adjustment
Steering Dual
Rate
Loosen to
Adjust
Outdrive