Pro Boat PRB3450 - Manual (Page 13)

13
EN
 1. Slide the battery cover off in the
directions shown to access the battery
compartment.
 2. Install four AA-size batteries in the
transmitter. Make sure to match the
polarity of the batteries to the polarity
molded into the battery compartment
of the radio. Slide the cover back into
position on the radio.
 3. Slide the power switch on the
transmitter to the ON position. Move the
receiver switch to the ON position.
 4. Move the stick on the transmitter to
the right. The rear edge of the rudder
will move to the right as shown. Actuate
the STR (steering) reversing switch if the
direction is reversed.
Rear Edge
Note: If you find the boat is turning too
quickly, you can reduce the amount of
rudder by adjusting the dual rate knob on
the top of the transmitter.
Transmitter Battery Installation and Checking the Controls