Pro Boat PRB3450 - Manual (Page 20)

20
EN
PRB3467 Railing (Front)
PRB3468 Railing (Rear)
PRB3469 Mast
PRB3470 Boom (Front and Rear)
PRB3471 Boom Turnbuckle
PRB3472 Spreader
PRB3473 Jib Stay (7 pc)
PRB3474 Snaps (10 pc)
PRB3475 Main Sail
PRB3476 Jib Sail
PRB3477 Boat Stand
PRB3478 4.8V Ni-MH Battery
PRB3479 Switch Harness
PRB3480 Sail Winch Servo
SPMMR200 Receiver
SPMR2200 Transmitter
PRB3451 Hull
PRB3452 Switch Cover and Nut
PRB3453 Capstan (4 pc)
PRB3454 Pulley Sets
PRB3455 Railing Stand (16 pc)
PRB3456 Jack Stays (4 pc)
PRB3457 Steering Wheel Set
PRB3458 Rudder with Arm
PRB3459 Anchor
PRB3460 Balloon with Strap
PRB3461 Rigging Line
PRB3462 Railing Line
PRB3463 Winch Retaining Ring
PRB3464 Ballast
PRB3465 Hatch
PRB3466 Railing Post (6 pc)
Instructions for Disposal of WEEE by Users in the European Union
This product must not be disposed of with other waste. Instead, it is the user’s responsibility
to dispose of their waste equipment by handing it over to a designated collection point for the
recycling of waste electrical and electronic equipment. The separate collection and recycling of
your waste equipment at the time of disposal will help to conserve natural resources and en-
sure that it is recycled in a manner that protects human health and the environment. For more
information about where you can drop off your waste equipment for recycling, please contact your local
city office, your household waste disposal service or where you purchased the product.
FCC Information
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate the equipment. This product contains
a radio transmitter with wireless technology which has been tested and found to be compliant with the applicable
regulations governing a radio transmitter in the 2.400GHz to 2.4835GHz frequency range.
Antenna Separation Distance
When operating your transmitter, please be sure to maintain a separation distance of at least 5 cm between your
body (excluding fingers, hands, wrists, ankles and feet) and the antenna to meet RF exposure safety requirements
as determined by FCC regulations.
The illustrations below show the approximate 5 cm RF exposure area and typical hand placement when operating
your transmitter.
Replacement Parts