PS Engineering PXE7300 Installation Manual - Manual (Page 14)

PS Engineering
PXE7300
Installation and Operator’s Manual
200-973-0002 Page 3-1 April 2006
Section III OPERATION
GENERAL INFORMATION
3.1 SCOPE
This section describes the operation of the PXE7300 In-Flight Entertainment system.
Operating controls consist of two rotary knobs with push-push switches, and four buttons.
Figure 3-1 Front Panel Controls
3.2 Operating Controls
The single-disk player is designed for simple operation. The Disc player will begin to play automatically
when a Disc is inserted (unless the disc is specially formatted as 7300 volume, see section 3.4). The disc
will play through in order, and then stop at the end. If a disc is not inserted, the unit will be in the FM
radio mode.
NOTE:
When a disc is inserted, the display will show “Reading . . .” for up to 20 seconds, depending on the media
and amount of information contained.
3.2.1 Power/Volume Control (1)
The PXE7300 system is turned on and off by pushing the volume (left hand) knob. The left knob is the
volume control. Turning the knob clockwise will increase the volume.
3.2.2 Stop/Eject Button (2)
The Stop/Eject button will stop the disc. Hold for 3 seconds to eject the disc.
In AM or FM Radio Mode, this button scans up the frequency band for a strong signal.
3.2.3 Play/Pause Button (3)
Pressing the play/pause button momentarily will pause the player. Press for about one second to advance
the track or select another random track. Press and hold the PLAY/PAUSE to for an INTRO SCAN that
plays a few seconds of each track before advancing.
Momentarily pressing STOP/EJECT & PLAY/PAUSE buttons at the same time will cause the track to
jump backward.
NOTE:
The MP3 mechanism in the PXE7300 is more sensitive to scratches on the play side of the disc than tradi-
tional CD players. It is suggested to use CDs that have few to no scratches for optimum performance.