PS Engineering PXE7300 Installation Manual - Manual (Page 15)

PS Engineering
PXE7300
Installation and Operator’s Manual
200-973-0002 Page 3-2 April 2006
In AM or FM Radio Mode, this button scans down the frequency band for a strong signal.
3.2.4 The R/S Button (4)
This selects random or sequence play in the disc mode.
3.2.5 The Data Knob (5)
In the Disc mode (CD or MP3), the knob will advance (CW) or decrease (CCW) the track. Track number is
displayed when the knob is in motion. Then it will display the track name and then begin to play.
In AM or FM radio mode, this knob can be used to tune the radio directly.
If the playing media is an MP3 format, the pushing the DATA knob will display the data (if stored and
available) from the playing tracks in sequence when the knob is pushed.
! Song Name
! MP3 Actual File Name
! Album
! Artist
Depending on the total size of the information stored on the disc, the available data may be truncated in the
following manner: Small number of files, Actual File Name, Larger number of files, Truncated File Name,
Most files, Track Number.
3.2.6 The MODE Button (6)
This button cycles through the operating modes, Disc, FM, AM, and AUX (if enabled).
3.3 Radio Reception
The passive AM/FM antenna, part number 510-730-0001 (included) is optimized for FM radio perform-
ance. Therefore, when used for AM reception, the operator may only receive the most powerful 3 to 5 AM
stations. In contrast to an ADF, where audio fidelity is not important, the PXE7300 requires higher signal
levels to ensure fidelity.
For optimum performance, some installers may desire an external AM/FM antenna. PS Engineering rec-
ommends a Comant CI-222-L.
Another alternative is to connect the PXE7300 antenna input to an unused VOR port of the VHF NAV
antenna splitter. Do NOT add another splitter.
3.4 Radio Preset Function
The PXE7300 can save up to nine AM and nine FM frequencies for future recall. Select the desired radio
frequency.
To set press the “R/S” button (4). The next available slot will be displayed as “S#.” (# being the available
memory location). Within five seconds, select the desired frequency using the DATA knob (if not already
displayed). Press the R/S (4) again to save the selection. The display will flash, indicating a successful
save.
You can select the “S” slot by pressing the Stop (up) and play (down) buttons.
To access the channel, press the DATA knob (5) the radio mode, and select the preset with the DATA
knob or scan up (2) and down (3) buttons.