PS Engineering PMA450 Installation Manual User Manual
PS Engineering Accessories communication
Advertising
Table of contents
Document Outline
- Section I – GENERAL INFORMATION
- Section II - INSTALLATION
- GENERAL INFORMATION
- Unpacking and Preliminary Inspection
- Equipment Installation Procedures
- Cable Harness Wiring
- Intercom wiring
- Marker Beacon Installation
- User Adjustments
- Communications Antenna Installation Notes
- PMA450 Pin assignments
- Wiring Checkout
- Unit Installation
- Operational Checkout
- Final Inspection
- Section III OPERATION
- SCOPE
- Power and Fail Safe (1)
- Menu Selection (6)
- Communications Transmit (XMT) Selection (2)
- COM Audio Selector (3)
- Speaker Amplifier (7)
- Marker Beacon Operation (9) (unit part number 050-450-0100, only)
- Intercom Operation (8)
- Music and Music Muting
- Bluetooth® connection
- Bluetooth® Telephone Mode
- Internal Recorder and playback
- User Setup menus
- LCD Adjustment
- USB Charging Port (10)
- Section IV – Warranty and Service
- Appendix A – PMA450 Installation Drawings
- Appendix B – J1 Connector Interconnect
- Appendix C – J2 Connector Interconnect
- Appendix D – Instructions for FAA Form 337 and continuing air
- worthiness
- Appendix E – RTCA DO160G Environmental Qualification Form