PS Engineering DRAWS - Manual (Page 11)

PS Engineering
PRD60 Remote DRAWS Unit
Installation and Operator’s Manual
200-160-0200 Page 4-1 Rev 3, Sept. 2012
Section IV- Warranty and Service
4.1 Warranty
In order for the factory warranty to be valid, the installations in a certified aircraft must be accomplished
by an FAA-certified avionics shop and authorized PS Engineering dealer. If the unit is being installed by
a non-certified individual in an experimental aircraft, a factory-made harness must be used for the war-
ranty to be valid.
PS Engineering, Inc. warrants this product to be free from defect in material and workmanship for a pe-
riod of one (1) year from the date of sale. During the twelve (12) months of the warranty period, PS En-
gineering, Inc., at its option, will send a replacement unit at our expense if the unit should be determined
to be defective after consultation with a factory technician.
All transportation charges for returning the defective units are the responsibility of the purchaser. All do-
mestic transportation charges for returning the exchange or repaired unit to the purchaser will be borne by
PS Engineering, Inc. The risk of loss or damage to the product is borne by the party making the shipment,
unless the purchaser requests a specific method of shipment. In this case, the purchaser assumes the risk
of loss.
This warranty is not transferable. Any implied warranties expire at the expiration date of this warranty.
PS Engineering SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.
This warranty does not cover a defect that has resulted from improper handling, storage or preservation,
or unreasonable use or maintenance as determined by us. This warranty is void if there is any attempt to
dissemble this product without factory authorization. This warranty gives you specific legal rights, and
you may also have other rights, which may vary from state to state. Some states do not allow the exclusion
of limitation of incidental or consequential damages, so the above limitation or exclusions may not apply
to you.
All items repaired or replaced under this warranty are warranted for the remainder of the original war-
ranty period. PS Engineering, Inc. reserves the rights to make modifications or improvements to the prod-
uct without obligation to perform like modifications or improvements to previously manufactured prod-
ucts.
4.2 Factory Service
The unit is covered by a one-year limited warranty. See warranty information. Call PS Engineering, Inc.
at (865) 988-9800 before you return the unit. This will allow the service technician to provide any other
suggestions for identifying the problem and recommend possible solutions.
After discussing the problem with the technician and you obtain a Return Authorization Number, ship
product to:
[Note: PS Engineering will not be responsible for items shipped in US Mail.]
PS Engineering, Inc.
Attn: Service Department
9800 Martel Rd
Lenoir City, TN 37772
(865) 988-9800 FAX (865) 988-6619