PS Engineering PAV80 Installation Manual - Manual (Page 15)

PS Engineering
PAV80 Series IFE System
Installation and Operator’s Manual
200-800-0101 Page 2-7 Rev 6 Sept. 2005
Figure 2-8 PVA802 Dist. Amp Circuit
breaker location (Typical)
Connect the PVA802 to a 5-amp PULL TYPE circuit breaker. The unit connector is a crimp type, however,
we recommend soldering the small
conductors from the RG179 coax.
NOTE: This unit can become warm when
fully loaded, and should not be mounted
where an occupant may have inadvertent
contact with it.
The PVA802 should be mounted in
accordance with AC43.13-2A, for remote
mounted equipment that does not require
shock mounting (Chapter 2, Section 24(b)). This
also includes any supporting structure that may be fabricated, in
accordance with Chapter 2, Sections 25 and 26.
Figure 2-9 View of typical PVA802 Installation
2.8 Internal Adjustments
None
2.9 Post Installation Checkout
After wiring is complete, verify power is ONLY on pins 21 and Y of the connector, and airframe ground
on bottom connector pin 22. Failure to do so will cause serious internal damage and void PS Engineering's
warranty.
2.9.1 System Checkout
1. Insert disc, and verify that the player accepts the disk with about ½ of the diameter in the unit. The
player should pull the disk smoothly and drop into place.
2. Apply power to the display unit.
3. Verify that the display unit has either the movie opening (if DVD) or the blue background with track
information (Music CD or MP3)
4. Verify that all Disc modes operate.
5. Push the “Eject” button and verify that the disc is ejected within about 10 seconds.
6. Verify radio operation on AM and FM
7. Verify that aux audio/video is presented to the output (if connected).
8. Evaluate the audio interface to be certain that the IFE audio is muted during intercom and radio com-
munication.
a. If muting override is provided, evaluate the switch location and verify operation.