Warranty and service – PS Engineering PCD7100-I Pilot’s Guide User Manual

Page 6

Advertising
background image

6

Rev. 2

PCD7100-I -Pilot Guide

tons to press to start recording. The system automatically begins to record
the instant the radio becomes active. Only aircraft radio audio in pilot’s
headset is recorded and only the pilot will hear the playback audio, in one
ear.

1.5.1 Operation

Recording is automatic; there is no action required by the pilot. To play
back the last recorded message, simply press the momentary switch associ-
ated with the IRS. Each additional press of the button will play the preced-
ing recorded message.
To stop playback, hold the playback button for two seconds. The next push
will then play the prior message.

Creating MP3s on your home computer, from an Audio CD

Start MusicMatch JukeBox.(

www.musicmatch.com

) Press the recorder

button, which is the small red dot located in the top right corner. This will
open the recorder window located at the bottom of the screen.

Insert an audio CD into your computer’s CD drive. MusicMatch will auto-
matically read the disc and display the contents in the recorder window.
Press the REFRESH button to check the Internet database for CD informa-
tion, such as artist, song title, or album. If this information is available, it
will automatically be updated in the file.

Select Options->Recorder->Format and select either MP3 or MP3PRO
format. You may also set the MP3 file quality under the Options-
>Recorder->Quality menu.

NOTE:

For best results (reduced skipping, etc.) burn rate of the disc should

not exceed the published rate of the media, or 2X, whichever is lower.

Select the tracks to be copied to MusicMatch by checking the box next to
the desired track. Press the record button in the lower left corner when
complete

MusicMatch will then convert the files from the audio CD to MP3 and dis-
play them in the Music Library box located in the middle of the screen.

Warranty and Service

2.1 Warranty

In order for the factory warranty to be valid, the installations in a certified
aircraft must be accomplished by an FAA-certified avionics shop and au-
thorized PS Engineering dealer. If the unit is being installed by a non-
certified individual in an experimental aircraft, a factory-made harness

Advertising