Crestron electronic GreenLight DIN-8SW8 - Manual (Page 15)

Crestron DIN-8SW8 DIN Rail High-Voltage Switch
The DIN-8SW8 is designed for installation on a DIN rail. Refer to the
following diagram when installing.
Installing the DIN-8SW8
1. Place the top of the DIN-8SW8’s rail mount over the top of the
DIN rail.
2. Tilt the bottom of the DIN-8SW8 toward the DIN rail until it snaps
into place.
NOTE: When mounting DIN rail products, it may be necessary to
use a flat-head screwdriver to pull the DIN rail release tab while
snapping the device onto the DIN rail.
To remove the DIN-8SW8 from the DIN rail, use a small, flat object (i.e.,
a flat-head screwdriver) to pull the DIN rail release and tilt the bottom of
the DIN-8SW8 away from the DIN rail.
NOTE: Certain third party DIN cabinets provide space for an
informational label between each DIN rail row. Crestron’s Engraver
software (version 4.0 or later) can generate appropriate labels for all
Crestron DIN rail products.
Operations & Installation Guide – DOC. 6666B DIN Rail High-Voltage Switch: DIN-8SW8 • 11