Electronic throttle control (etc) indicator light, Air bag warning light, Fuel cap/loose gas cap message – Ram Trucks 2013 С/V - User Guide User Manual

Page 96: Change oil” message, What to do in emergencies

Advertising
background image

- Electronic Throttle Control (ETC) Indicator Light

• This light informs you of a problem with the system.

• If a problem is detected, the light will come on while the engine is running. Cycle

the ignition when the vehicle has completely stopped and the shift lever is placed
in the PARK position; the light should turn off.

• If the light remains lit with the engine running, your vehicle will usually be

drivable; however, see an authorized dealer immediately. If the light is flashing
when the engine is running, immediate service is required and you may experience
reduced performance, an elevated/rough idle or engine stall and your vehicle may
require towing.

- Air Bag Warning Light

• If the light is not on during starting, stays on, or turns on while driving, have the

vehicle serviced by an authorized dealer immediately.

Fuel Cap/Loose Gas Cap Message

• If a “gas cap” message (shown as gASCAP) appears, tighten the gas cap until a

“clicking” sound is heard.

• Press the odometer reset button, located below the tachometer, to turn the

message off.

• If the message continues to appear for more than three days after tightening the

gas cap, see your authorized service center.

“CHANGE OIL” MESSAGE

• If a “Change Oil” message appears and a single chime sounds, it is time for your

next required oil change.

Resetting The Light After Servicing

Vehicles Equipped With Keyless Enter-N-Go™

• Without pressing the brake pedal, push the ENGINE START/STOP button and

cycle the ignition to the ON/RUN position (Do not start the engine.)

• Fully depress the accelerator pedal, slowly, three times within 10 seconds.

• Without pressing the brake pedal, push the ENGINE START/STOP button once to

return the ignition to the OFF/LOCK position.

Vehicles Not Equipped With Keyless Enter-N-Go™

• Turn the ignition switch to the ON/RUN position (Do not start the engine.)

• Fully depress the accelerator pedal, slowly, three times within 10 seconds.

• Turn the ignition switch to the OFF/LOCK position.

NOTE:
If the indicator message illuminates when you start the vehicle, the oil change indicator
system did not reset. If necessary, repeat this procedure.

WHAT TO DO IN EMERGENCIES

94

Advertising