Flash lamps with remote key lock – Ram Trucks 2014 Chassis Cab Commercial - Owner Manual User Manual

Page 28

Advertising
background image

NOTE:

Pressing the LOCK button on the RKE transmit-

ter while you are inside the vehicle will activate the
Vehicle Security Alarm System. Opening a door with the
Vehicle Security Alarm System activated will cause the
alarm to sound. Press the UNLOCK button to deactivate
the Vehicle Security Alarm System.

Flash Lamps With Remote Key Lock

This feature will cause the turn signal lights to flash when
the doors are locked or unlocked with the RKE transmit-
ter. This feature can be turned on or turned off. To change
the current setting, proceed as follows:

• For vehicles equipped with the EVIC, refer to “Electronic

Vehicle

Information

Center

(EVIC)/Customer-

Programmable Features (System Setup)” in “Under-
standing Your Instrument Panel” for further information.

• For vehicles not equipped with the EVIC, perform the

following procedure:

1. Press and hold the UNLOCK button on a programmed

RKE transmitter for at least four seconds, but no
longer than ten seconds. Then, press and hold the
LOCK button while still holding the UNLOCK button.

2. Release both buttons at the same time.

3. Test the feature while outside of the vehicle by press-

ing the LOCK/UNLOCK buttons on the RKE trans-
mitter with the ignition switch in the OFF position and
the key removed.

4. Repeat these steps if you want to return this feature to

its previous setting.

26

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Advertising