RED DSMC MEDIA - Manual (Page 33)

RED DSMC MEDIA OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC 955-0047, REV-F | 33
REMOVE SIDE MEDIA MODULES
Follow the instructions in this section to remove any of the following modules from the DSMC BRAIN:

RED MINI-MAG Side SSD Module

Carbon Fiber RED MINI-MAG Side SSD Module

DSMC 1.8" SSD Side Module

DSMC 1.8" SSD Side Module (DRAGON)

Carbon Fiber DSMC 1.8" SSD Side Module (DRAGON)
REQUIRED TOOL: T10 Torx ® driver
1. Power down the camera.
2. Use a T10 Torx driver to remove the four (4) cap screws that attach the module to the BRAIN in a cross
pattern. The screw types for the side SSD modules are listed below:
‒ Aluminum side SSD modules: Black M3x0.5 x 6 mm or M3x0.5 x 5.5 mm cap screws.
‒ Carbon fiber side SSD modules: Red M3x0.5 x 6 mm cap screws that come with the carbon fiber DSMC
BRAIN.
3. Remove the module from the DSMC BRAIN.
4. Inspect the connections and pins on the DSMC BRAIN and ensure that they are clean and undamaged.
NOTE: DO NOT remove the two (2) red and black tamper-proof stickers.
Remove Screws
Inspect Connections