RED DSMC MEDIA - Manual (Page 35)

RED DSMC MEDIA OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC 955-0047, REV-F | 35
INSTALL THE REAR SSD MODULE
The REAR SSD MODULE attaches to the DSMC system the same way that the other rear modules attach to the
system. For more information about installing rear DSMC modules, see the DSMC Operation Guide available at
www.red.com/downloads .
NOTE: DO NOT attempt to insert the RED MINI-MAG in the REAR SSD MODULE.
EJECT MEDIA FROM CAMERA (UNMOUNT)
IMPORTANT: To ensure data integrity, media must always be unmounted prior to removal from the camera. This
ensures that power is removed from the digital media and any open data files are closed. Failure to properly
unmount media may result in lost data or corrupted files.
Removing an SSD without first unmounting it will not physically damage the media, however it does increase
the risk of file corruption, so it’s good operational practice to unmount the media if possible before removing or
disconnecting. Unmounting the digital media takes a few seconds, protects the integrity of your recorded data,
and helps clips mount instantly to your workstation in post-production.
NOTE: Improper removal of media without first unmounting the SSD will result in a warning notification: “Media
removed without first ejecting. Data integrity risk.” Always unmount media before physically removing the disk
to protect your media and footage.
To eject media, follow the instructions below:
1. Eject the media using one of the following modules:
‒ REDMOTE/Touchscreen LCD: Go to Menu > Media > Eject Media.
‒ DSMC SIDE HANDLE: Press User Key 7 (lowest of the system keys). The default function for this key is Eject
Media; however, you can remap this key.
‒ Side media module: Press User Key 1 + 2. The default function for this key combination is Eject Media;
however, you can remap this key combination.
When media is ejected, Viewfinder output(s) display “Media ejected successfully. It is now safe to remove
media”.
2. Remove media from the camera.
REAR SSD MODULE