Canon CR-50 - Manual (Page 11)

11
Power Supply
• Connect only to a power outlet of the rated voltage and power supply
frequency (either 120V, 60 Hz or 220-240V, 50/60 Hz, depending on
your region).
• Make sure that the scanner is connected to an independent power
outlet. Do not plug the scanner into an outlet shared with another
device. If you use an extension cord, make sure that the extension
cord is rated for the current requirements of the scanner.
• If you are unsure of anything relating to the power supply, contact
your local authorized Canon dealer or service representative for
further information.
• Never place an object on top of the power cord or step on the power
cord.
• Never bundle the power cord or wrap the cord around an object,
such as a table leg.
• Do not tug on the power cord. When you remove the power cord, grip
it by the power plug head.
• Keep the area around the power outlet free of obstacles.
• Connect only to a power outlet of the rated voltage and power supply
frequency (either 120V, 60 Hz or 220-240V, 50/60 Hz, depending on
your region).
• Do not connect to power outlets with other electrical devices. Also,
when using an extension cord, make sure that the extension cord is
rated for the current requirements of the scanner.
• Disassembling and/or reassembling the AC adapter is extremely
dangerous and should not be attempted under any circumstances.
• Do not place heavy objects on the AC adapter or power cord. Do not
place the adapter or cords in an area where they are likely to be
stepped on.
• Do not use the power cord while it is bundled.
• Never pull directly on the power cord. To remove the plug from the
outlet, grasp the plug directly and remove it from the outlet.
• Keep the area around the power plug clear of articles so that the
power plug can be disconnected in an emergency.
• Use only the AC adapter provided with the product. Do not use the
scanner’s AC adapter with any other product.
• If you have any questions about the AC adapter, contact your local
authorized Canon dealer or service representative for further
information.
Moving the Scanner
When you move the CR-50/80, hold it firmly with both hands and carry
it carefully. Do not hold the scanner by the Eject Stopper. The scanner
weighs approximately 2 kg (4.4 lb).
WARNING
When moving the scanner, be sure to turn OFF the power and
remove any cables. If the cables are not removed before moving
the scanner, you may damage the plugs or connector by forcibly
pulling them out.