4 wiring slc detectors, Wiring slc detectors – SilentKnight 5600 User Manual
Page 61
SLC Device Installation
151450
5-5
5.4
Wiring SLC Detectors
This section describes how to install heat and smoke detectors. All detectors ship
with installation instructions. Refer to the detector’s installation instructions for more
detailed information.
This information applies to the following HFS or SK models:
•
HFS-P, HFS-PA, SK-Photo - Photoelectric Smoke Detector
•
HFS-PT, HFS-PTA, SK-Photo-T - Photoelectric Smoke Detector with Thermal
•
HFS-D, HFS-DA, SK-Duct - Photoelectric Duct Detector
•
HFS-T, HFS-TA, SK-Heat - Fixed Temperature Detector
To wire HFS or SK detectors:
1. Wire device bases as shown in Figure 5-3.
2. Set the address for each device as described in Section 5.5.
Figure 5-3 Heat and Smoke Detector Connection to the Panel.
Supervised
Power limited